Getting Connected Quickly

Before attempting a new audio stream connection please connect and adjust the following:

 

1.Attach power to the codec.

2.For IP connections, attach RJ45 Ethernet cables to at least one of the ETH ports on the codec's rear panel. Attach cables to ISDN or POTS modules inserted in your codec as required.

3.Attach headphones to the 6.35mm (1/4") headphone jack on the codec's front panel.

4.Check that the correct country is selected in the codec.

i.Press the SETTINGS Settings button button.

ii.Navigate to System and press the Ok button button.

iii.Navigate to Country and press the Ok button button.

iv.Use the navigation buttons to select your country of operation and press the Ok button button.

5.Make sure you know the IP address, or line numbers for dialing over ISDN or POTS to the destination codec.

 

information2

Important Note: It is important to set the correct country setting for connections over POTS to adjust the POTS G5 module for varying line voltages in different countries. The country setting also affects whether G.711 µ-Law (North America/Japan) or A-Law (Europe/Australasia) coding is used over IP, SIP and ISDN connections.