By default the codec by is configured to both encode and decode data. However, it is possible to configure the codec to either encode or decode audio data only. This is useful for:

 

•Conserving connection bandwidth when unidirectional data streaming is required.

•Lowering data costs.

•Increasing overall connection reliability.

 

Program the transmitting codec to encode only and program the receive codec to decode only when using this feature. To adjust this setting:

 

1.Press the HOME button to return to the Home screen.

2.Use the navigation buttons on the front panel to select Connect and press the button.

3.Select IP and press .

4.Select your preferred IP Session mode and press the button.

5.Use the down navigation button to select Setup and press .

6.Navigate to Dir and press .

7.Select Encode Only or Decode Only and press .