Configuring Auto Reconnect
Contents
Auto Reconnect is disabled by default. When enabled, the dialing codec attempts to reconnect if data is temporarily lost over a connection.
|
Important Note: When Auto Reconnect is enabled, the dialing codec will continue to attempt a connection with the remote codec until Disconnect is pressed either on the dialing codec's keypad, or in the web-GUI. |
Auto Reconnect using IP
1.Press the HOME 
button to return to the Home screen, select Connect, then select IP and press the 
button.
2.Select the IP Session mode you are using to connect.
3.Select Setup and press .
4.Navigate to Auto Recon and press to toggle between Enabled and Disabled.
Auto Reconnect using ISDN
1.Press the HOME button to return to the Home screen, select Connect, then select ISDN and press the button.
2.Navigate to Auto Recon and press to toggle between Enabled and Disabled.
Auto Reconnect using POTS
1.Press the HOME button to return to the Home screen, select Connect, then select POTS and press the button.
2.Select Setup and press .
3.Navigate to Auto Recon and press to toggle between Enabled and Disabled.