Bridge-IT XTRA User Manual v3.0 (Firmware v2.16.xx)

Zoom Window Out
Larger Text | Smaller Text
Hide Page Header
Show Expanding Text
Printable Version
Save Permalink URL

Configuring Auto Reconnect

Auto Reconnect is disabled by default. When enabled the dialing codec attempts to reconnect if data is temporarily lost over an IP connection. To adjust the setting:

1.Press the HOME home button button to return to the Home screen, select Connect, then select IP and press the Ok button button.

2.Select the IP Session mode you are using to connect.

3.Select Setup and press Ok button .

4.Navigate to A/Recon and press Ok button to toggle between Enabled and Disabled.

information2

Important Note: When Auto Reconnect is enabled, the dialing codec will continue to attempt a connection with the remote codec until Disconnect is pressed either on the dialing codec's keypad, or in the web-GUI. This setting should only be configured on the dialing codec.