Dialing a SIP Address via the Codec Front Panel

1.Press the HOME home button button to return to the Home screen, then select Connect > IP > SIP and press the Ok button button.

2.Use the KEYPAD to enter any combination of alphabetic and numeric characters in the SIP address of the codec you want to dial. Use the star button or hatch button buttons to enter the periods in the SIP address and use the RETURN Back button button to delete any numbers already entered. Alternatively, if you have dialed the SIP address previously, press the RETURN Back button button to view the Recent Call screen and select the SIP address you want.

 

SIP-address entered

 

3.Press the down down arrow button navigation button to select Setup and press Ok button, then adjust the algorithm, jitter buffer, encode/decode direction, port and auto reconnect settings if required.

4.Press the RETURN Back button button to navigate backwards to the Connect SIP screen and select Save to name and save the program.

5.Press the CONNECT connect button button to make a connection.

 

information2

Important Notes:

•See Configuring SIP Settings for instructions on entering SIP account details into the codec. If your codec is registered with same SIP registrar as the destination codec then you only need to enter the SIP user name to dial successfully.

•If you don't save the program during configuration, a temporary program is created after you dial the SIP connection for the first time using the codec KEYPAD. The temporary program will appear in the recent calls list if you want to redial the program.

 

SIP-program displayed in program list

 

It is also possible to configure SIP programs using the Toolbox web-GUI. See the section titled Configuring SIP Programs for more information.