USB drivers need to be installed on your PC in order to connect successfully to the codec using the USB port. To install drivers:

1.Download the zipped USB driver ".inf" file from the Bridge-IT firmware download pages at http://www.tieline.com/Support/Latest-Firmware.

2.Unzip the file and save it to your PC.

3.Connect a USB cable between your PC and the Bridge-IT USB port on the rear panel of the codec.

4.Older PCs should detect that a new device has been attached and launch the Found New Hardware Wizard. Note: If the wizard doesn't launch automatically, please navigate to Control Panel > System in Windows to verify the status of the driver installation. Install the Microsoft RNDIS driver for the codec if required.

5.Select Install from a list or specific location (Advanced) and click Next.

6.Select the folder in which you have saved the downloaded ".inf" file and click Next.

7.When the drivers have been installed click the Finish button.