Please enable JavaScript to view this site.

Gateway and Gateway 4 Manual v1.5

When dialing over IP you can select the preferred interface to use when establishing a connection. By default Any is selected, which means the first available interface will be used to dial a connection. The default Via interfaces in order of use when available are:

 

1.LAN1 Ethernet port (default Primary Via interface)

2.LAN2 Ethernet port (default Secondary Via interface)

3.Wi-Fi (default Tertiary Via interface)

 

information_symbol

Important Notes:

If an interface is not available it is not listed in the Via interface selection screen. E.g. if Wi-Fi is not configured it will be unavailable.

If none of the 3 primary, secondary, and tertiary interfaces listed are available, the codec will look for the first available interface in the following order: LAN1; LAN2; VLANs.

VLAN interfaces have features similar to physical Ethernet interfaces. However, your network administrator will need to configure VLAN support throughout your network for them to be supported in your codec.

 

Reconfigure Default Primary, Secondary and Tertiary Interfaces

It is possible to reconfigure the default Primary (Ethernet 1), Secondary (Ethernet 2) and Tertiary (Wi-Fi) interfaces in the codec. As an example, you may want to select Primary as the dialing interface in a program and then copy this program onto multiple codecs. However, the actual primary interface used at each location can vary for each codec. For one codec it may be an Ethernet port and for another it may be a Wi-Fi interface. This allows you to configure site-specific settings to suit available network interfaces at different remote locations.

 

1.Press the SETTINGS Settings_button button.

2.Use the navigation buttons to select IP Options and press the Ok_button button.

 

Settings-IP_options

 

3.Navigate to IP Via Setup and press the Ok_button button.

 

IP_options-IP_via_Setup

 

4.Navigate to the Primary, Secondary or Tertiary IP Via interface setting and press the Ok_button button.

 

IP_via_Setup-LAN1_selected

 

5.Select an alternative default interface and press the Ok_button button.

 

IP_Via_Select-Primary_interface_select

 

6.Press the Return Return_button  button to navigate out of the menu, then navigate to Save in the confirmation dialog and press the Ok_button button to save all changes.

 

IP_via_Setup-Confirmation_dialog

 

information_symbol

Important Note: Fuse-IP cannot be configured as a default Primary, Secondary or Tertiary interface.